- Description
- Related Files
- Discussion
Power supply module Holybro PM02D-12S HV The PM02D provides regulated battery power for your Pixhawk® 5X and 6X, as well as battery current and voltage measurement, all via a 6-pin cable. Built-in switching regulator supplies 5.2V and maximum 3A from LiPo batteries up to 12S (HV). The power module is supplied fully assembled with XT60 connectors, shrink-wrapped to protect against physical damage. It is not intended to power the servos, use your aircraft's ESC/BEC for that. The 2.00 mm pitch Molex CLIK-Mate Wire-to-Board connector is rated for 3.0 A per contact. - The PM02D HV version is supported by the PX4 system. It is supported for Ardupilot in version 4.4 and later. The full setup guide can be found here. - This PM uses I2C digital signal data output, compatible with Pixhawk 5X/6X series. - NOT compatible with flight controllers that use analog PM such as Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5 or Durandal flight controllers. - Comparison table of power modules Specifications: - Input voltage: 2S-12S - PCB Cont. Current load: 60A - PCB Burst Current Rating: 60A (<60s) - Maximum current sensing: 327A - Voltage and current monitor with I2C compatible interface - Outputs 5.2 V and max. 3 A - Weight: 20 g The package contains: - 1 x PM02D power supply module - 1 x 6-pin cable with a pitch of 2.00 mm
Let customers speak for us
Was easy and good fit for my Era mini 3.5 drone 😜
Gedas Mo
good product, correct price
Bjorn Geuns
Works great and matches expectations
Mindaugas
Great
Renatas Vitkevicius
Puikūs, gerai laikosi,lengvai užsideda. 10/10
Justas Leonavičius
Puikūs įrankiai, daug skirtingų galvučių
Anonymous
Labai gera antena, jaučiasi ryšio kokybės pagerėjimas
Anonymous
Conforme à la description
PHILIPPE COURTOIS
pirkau ant tinywhoop signalui gerint, siek tiek ilgesne nei tikejaus bet tiko
Paulius
Great
Juozas
Puiki kokybė
Valdas Kulišauskas
All was as expected and delivered on time
Anonymous
.
Anonymous
Viskas super 😉
Jurga Valentienė
Great quality
Anonymous
